Toolserver:LDAP
This page was moved from the Toolserver wiki.
Toolserver has been replaced by Toolforge. As such, the instructions here may no longer work, but may still be of historical interest.
Please help by updating examples, links, template links, etc. If a page is still relevant, move it to a normal title and leave a redirect.
- This works only on solaris at the moment!'
The Toolserver uses LDAP for local authentication.
To use certain services (such as subversion and phpMyAdmin) you will need to set your LDAP password. To do this, run the following command:
$ setpass
If your password is not strong enough, you might receive an error message from setpass. The password must be at least 8 characters long and contain at least two of the following character types: punctuation, numeric and alphabetical. If the password you choose is not strong enough, the error message will indicate the problem. Choose a new password, and run setpass
again.
If you forget your LDAP password, use the following command to reset it:
$ resetpass
To change your password, run:
$ passwd
Note: Your LDAP password cannot be used to log in via SSH. You must use SSH keys for that.
Your account email address is also stored in LDAP. To view or change it, run:
$ setmail
Older accounts may not have an LDAP email address set. In this case, setmail
will let you set the address.
If you don't have an LDAP e-mail address and don't know your password, you'll need to create a JIRA issue in the "Toolserver" project.
For more information, see mail.